IPMIT100 - Quick Start Guide
|
|
The IPmitter ceiling and wall access point (IPMIT100) has dual band technology and can simultaneously connect equipment to your LAN on both 5.8GHz and 2.4GHz channels |
Powering
Option 1 - Power from 12V DC (via the 2.1mm DC Socket), the current consumption is 300mA.
The IPMIT100 is polarity sensitive so connections must be made correctly.
Option 2 - Power using 48V PoE, in the RJ45 WAN/POE Socket
The IPMIT100 will take approximately 1 minute to boot up.
Indoor Wi-Fi Access Point
For more setup options see the full manual
To setup the IPMIT100, login to the interface on a browser on a Windows PC/ Laptop.
1. Open a web browser, input the IP address of the device. (default = 192.168.1.123)
The IPmitter may be on a different network IP range to the computer, to add another IP range to the Windows PC/ Laptop scan the QR code below for the "how to guide"
2. Input the username and password, and click Login.
Default login details are:-
Default IP |
192.168.1.123 |
Password |
ipmitter |
3. Go to "Wizard" on the left, then select the mode required.
AP Mode - Set this mode to allow the IPMIT100 to act as a Wi-Fi access point for devices to connect onto a wired network.
Repeater Mode - Set this mode for a Wi-Fi link of the IPmitter to another existing Wi-Fi network to "extend" and repeat the Wi-Fi signal. The network port then will act as an extension of the original existing network
LAN Port 1 Speed |
10Mbs / 100Mbs |
LAN Port 2 Speed |
10Mbs / 100Mbs |
Frequency |
2.4Ghz + 5.8Ghz |
Wireless Data Speed |
750Mbps |
Wireless Standard |
IEEE802.11AC/N/G |
PoE Voltage |
48V |
12V Input Option |
Yes |
Modes |
Access Point / Repeater |
Mounting |
Wall Or Pole (Not Supplied) |
Dimensions |
185 x 185 x 30mm |