<< Click to Display Table of Contents >> Navigation: RS485 Commands and Triggering > Connection |
RS485 Wiring for a DVR / NVR to a VOX400. |
To use RS485 with a PC you will need to obtain an RS485 converter.
For use with a PC and for RS485 parameter, please see overleaf
The connections below show RS232 out of a PC, this will need to connect to an RS485 converter. Some converters simply use Tx and Rx terminals, C is only required when using a screened or shielded cable as the GND (ground) connection.
The RS485 parameters are as follows:
Baud Rate |
9600 |
Data Bits |
8 |
Stop Bits |
1 |
Parity |
None |
Flow Ctrl |
None |