POE606 - Quick Start Guide
|
User Information •The PoE Switch must be installed in a clean, dry environment where it will not be exposed to high temperatures, moisture or excessive dust. •Do not touch the PoE Switch or any of its connections with wet hands. •Ensure the power is switched off if the PoE Switch is not in use for a long period of time. •There are no user serviceable parts in the PoE Switch and opening or attempting to repair the product will void the warranty. •Only use the PSU originally supplied with the product. •Do not install or use the device if the power cable is damaged.
|
The POE606 is a power 1Gbps 4 way switch that can supply up to 71W of power per port.
Designed for higher load POE CCTV Equipment such as PTZs or you can use it to power other devices such as PoE extenders.
Because of the very high 71W output per port the power supply is external to the switch supplied with it.
Setup Options Option 1 To power IP Cameras using the PoE switch then connect the IP Cameras using CAT5e/CAT6 Ethernet Cable, for longer distances we recommend using high quality cable, with solid copper cores. |
|
Option 2 Provide network infrastructure to PoE and non-PoE Devices, like computers, and other Network devices. |
|
LED Status Indicators
LED |
Condition |
Status |
Power |
|
The switch is receiving power |
|
The switch is not receiving power |
|
Network / Link |
|
The port is connected |
|
No connection to the port |
|
|
The port is transmitting or receiving data |
|
PoE |
|
The port is linked and providing power to a device |
|
The port is not providing power to a device |
Troubleshooting
Problem |
Possible Cause |
Solution |
No Power light on Switch |
No power to the device |
Check power to device from external source. Check that the power lead (IEC lead) is plugged in to the PSU and the PSU is plugged into the switch. |
Loose connection |
Check that the power lead (IEC lead) is plugged in to the PSU and the PSU is plugged into the switch. |
|
Network light not flashing |
Poor quality cable or termination |
Check the Ethernet cabling to your device is of good quality and is terminated correctly. |
No PoE on connected device |
Poor quality cable or termination |
Check the Ethernet cabling to your device is of good quality and is terminated correctly |
Total power consumption exceeded |
Check the load devices are not above the total power consumption of the switch. |
|
Cable length |
Check the distance of Ethernet cable to your device. Ethernet cables have a 100m maximum length. |
|
Slow flashing LEDs, No Network or PoE on load devices |
Faulty cable or device |
Turn the power off to the switch & unplug the load devices (Check Ethernet cabling to load devices). Leave the switch turned off for 10 seconds and then power the switch back up, plug each device back into switch individually to help troubleshoot the suspect cable. |
Specification
Downlinks |
4 x RJ45 |
Uplinks |
2 x RJ45 |
PoE |
71W (Max per port) |
Power |
250W (Whole device maximum) |
Bandwidth |
10/100Mbps/Full Gigabit |
Use |
Internal Use Only |
Working Temperature |
0°C ~ 40°C |
Power Input |
240V AC (PSU and Lead supplied) |
Dimensions |
W118 x D95 x H28mm |