<< Click to Display Table of Contents >> Navigation:  Pairing > ERR Code or P-95

Note: The strength will range P-01 (Good) to P-75 (Poor).

 

If ERR shows then the IPmitters have not paired

 

Reset both IPmitters, holding the R (reset) button down on both IPmitters for 10 seconds. Once both units have booted back up, then try the pairing process again.

 

Note: Ensure the units are not plugged into the same switch / network during pairing.

 

 

If P-95 shows the the IPmiiters have either not paired or they have lost signal.

 

1. Check the pairing > Reset both IPmitters, holding the R (reset) button down on both IPmitters for 10 seconds. Once both units have booted back up, then try the pairing process again.

 

2. Between P-070 and P-095 is too low for transmission > Try the pairing process with the devices closer together.